1992 BMW AC Schnitzer

1992 BMW AC SCHNITZER

This BMW project was acquired in Winter of 2008. I had been bugging a friend of mine for this car for 4 years. I had always wanted an E36 BMW since I had seen this one. Over the past years I have owned and built several, however in late 2008 an issue with an un-repaired fuel leak and remote start resulted in this car bursting into a ball of flames. With lack of fire coverage I finally got this gem!

With some hard work over about a months time working here and there, after work and on weekends, I managed to get the car converted to 5 speed and back up and running again. The car currently features the following modifications, some came with the car and some were added during my restoration process.

Drivetrain:

  • 2.5L I6 DOHC
  • TMS Light weight Flywheel
  • SACH Racing Clutch
  • UUC Underdrive pulleys
  • Clutch Fan Delete
  • AC Delete
  • UUC Short Shifter
  • 3:91 LSD
  • TMS Jim Conforti Racing Chip
  • AC Schnitzer Exhaust
  • TMS Cold Air Intake

Suspension/Brakes/Wheels:

  • Billstein PSS9 Coil Overs
  • Durlin Carbon Fiber Offset Control Arm bushings
  • Brembo Cross Drilled Rotors
  • UUC Braided Steel Brake Lines
  • Bendix Ceramic Pads
  • AC Schnitzer Type III wheels 18″

Body:

  • Alpine White/Primer
  • M3 Door moldings
  • AC Schnitzer Body Kit
  • AC Schnitzer Wing
  • AC Schnitzer Mirrors
  • Smoked Taillights
  • Angel Eye Headlights

Interior:

  • AC Schnitzer floor mats
  • AC Schnitzer pedals
  • AC Schnitzer Door Sill plates

My Ex-Wife and I were leaving for Australia for 10 months so I did not have time to complete the car, however it has now left a great opportunity for all of you to see this car come to life!

See below to see the pictures of the transformation to get the car back up and running to where I left it before leaving for Australia!

Here is a list of what YOU the viewers will see during the finalization of this build on The Infamous Project:

  • Full body and Paint
  • Stainless Steel UUC Braided Brake Line install (6 piece kit)
  • DOT5.1 Racing Brake Fluid Install/Bleed
  • ABS Delete
  • PSS9 Coil Over kit installation and adjustment
  • TMS Header Installation and Custom Midpipe
  • 4 Point Roll Cage (still working on acquiring this)
  • Turner Motorsport Sway Bar Installation for front and rear
  • Front and Rear Strut tower braces
  • Custom white panel inserts for the interior
  • Stereo install and finalization
  • Overall Clean up!

Engine Removed

Image 3 of 10

One Comment

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

The Infamous Project © 2020. All Rights Reserved.